Adding another Frappe BENCH on same instance

This blog is a continuation of the following and part of a Six part training series. Watch all on Youtube.com/ERPGulf

https://cloud.erpgulf.com/blog/support-forum/installing-erpnext-version-15-on-ubuntu-23+

Here we are adding another BENCH on the same installation.

su - erpgulf

cd /opt

sudo mkdir bench2

sudo chown -R erpgulf:erpgulf /opt/bench2

cd /opt/bench2

yarn add node-sass

pip3 install frappe-bench

sudo apt install python3.11-venv

bench init frappe-bench --frappe-branch version-15

cd frappe-bench

sed -i '/web:/ s/$/ --noreload/' Procfile

bench start  ( This will throw error becasue the default ports like 8000,9000, 13000 are already used )

vim Procfile  ( and change port 8000 to 8010 or anything else )

vim config/redis_cache.conf ( change port from 13000 to 13010 )

vim config/redis_queue.conf ( Change port from 11000 to 11010 )

vim sites/common_site_config.json ( change port from 13000 to 13010 , 11000 to 11010 , 9000 to 9010 , 8000 to 8010 )

bench start ( Now it starts on 8010 )

bench new-site siteonbench2.erpgulf.com  --db-name newsite

bench setup supervisor --yes

bench setup nginx

cd config

mv nginx.conf ngix-siteonbench2.conf

mv supervisor.conf supervisor-siteonbench2.conf

vim supervisor-siteonbench2.conf

( change every programs, groups, and programs under groups names. Just add a "-2" at the end of every programs and groups. DOnt forget to change the programs named under groups also.)

sudo service supervisor restart ( Now ports 8000 and 8010 are open. check it by using telnet )

certbot certonly -d siteonbench2.erpgulf.com

vim ngix-siteonbench2.conf

change upstreams names there. and all other configuration we have explained in previous articles )

** There upstream names there inside nginx configuration, not just on the header ( on proxy-pass )

sudo cp supervisor-siteonbench2.conf /etc/supervisor/conf.d/

sudo service supervisor restart

sudo cp ngix-siteonbench2.conf /etc/nginx/conf.d/

sudo service nginx restart

If you want to restart on a section of supervisor for one particular bench, without disturbing others, use the following.

sudo supervisorctl restart frappe-bench-web-33:* ( assming your bech is on group 33 )

or to clear python caching on gunicorn on one bench only

sudo supervisorctl restart frappe-bench-web-33:frappe-bench-frappe-web-33

To see all supervisor processes/ programs

supervisorctl status

That't it

If you face any problem there, send a mail to support@ERPGulf.com we will try to help you.